PHONIC - XP

XP 5000

Details

XP 5000

5000 Watt Power Amplifier

  • 2500W + 2500W @ 2 ohm; 5000W @ 4 ohm bridged
  • Dual mono, high current power supply for increased reliability and performance
  • High-current toroidal transformers for greater two-ohm power and low noise
  • Independent user-defeatable clip limiters reduce distortion
  • Selectable high pass filters (30 Hz or 50 Hz) protect speakers and increase headroom
  • Balanced 1/4" (6.3 mm) TRS, XLR, and barrier strip inputs for maximum flexibility
  • Binding post and Speakon-type outputs
  • Selectable stereo, parallel & bridge mono amp modes
  • Ground lift switch to prevent hum
  • Signal level at -40, -20, -10, protect and clip LED indicators to monitor performance
  • Bridge mono and parallel mode indicators
  • Front mounted detented gain controls for easy access
  • Fast Recovery design for lower distortion at clipping
  • Advance protection circuitry guards against: short circuit, open circuit, thermal, ultrasonic, and RF protection, stable into mismatched loads, on/off muting, DC fault output crowbar
  • Three rack unit high
Top