ERNIE BALL - PEDALS

500K Stereo Volume/Pan Pedal

Details

VP Jr 25K (for Active Electronics)

Details

VP Jr 250K (for Passive Electronics)

Details

250K Mono Volume Pedal (for Passive Electronics)

Details

500K Stereo Volume/Pan Pedal

The dual potentiometer has a 500k ohm resistance suitable for the audio path of passive or active instruments. Attached to the footplate is a switch that provides the user two operating modes (volume or pan). Use the A input / A output for the left channel and the B input / B output for the right channel for stereo signals. For use with stereo cable installations using TRS type stereo plugs, use the B input and B output. For use as a mono volume pedal, use the A input and A output. For use as a typical pan pedal, switch the toe tap switch to the pan position and use only the A input. The pedal will pan the signal between the A and B outputs. Overall Volume Pedal dimensions: 4" W x 11" L x 2 3/4" H.

VP Jr 25K (for Active Electronics)

The potentiometer has a 25k ohm resistance suitable for an active audio path. Overall Volume Pedal Junior dimensions: 3.5" W x 10" L x2 3/8" H . The main pivot shaft is of centerless ground 1/2' diameter stainless steel, precision seated though nylon bushings at both ends. Tough long lasting Kevlar cable transmits pedal travel to the controls and is attached by stainless steel springs.

VP Jr 250K (for Passive Electronics)

The potentiometer has a 250k ohm resistance suitable for the audio path of passive instruments. Behind the jack area under the footplate is a micro taper switch which provides the user two distinct volume swell rates. Overall Volume Pedal Junior dimensions: 3.5" W x 10" L x2 3/8" H . The main pivot shaft is of centerless ground 1/2' diameter stainless steel, precision seated though nylon bushings at both ends. Tough long lasting Kevlar cable transmits pedal travel to the controls and is attached by stainless steel springs.

250K Mono Volume Pedal (for Passive Electronics)

The potentiometer has a 250k ohm resistance suitable for the audio path of passive instruments. Behind the jack area under the footplate is a taper switch, which provides the user two distinct volume swell rates. Overall Volume Pedal dimensions: 4" W x 11" L x 2 3/4" H. The main pivot shaft is of centerless ground 1/2' diameter stainless steel, precision seated though nylon bushings at both ends. The large center shaft diameter, in addition the strength factor, creates a broader stress bearing surface.

Top